Lumière Gelato Display

Lumière is equipped with a ventilated refrigeration system to ensure the even distribution of cold air inside the display case.
Gelato and Gelato/Pastry services.

The ventilated refrigeration system is equipped with a double evaporator and overhead air flow available both with a single and double air flow.

The perfect temperature for gelato reservation is continually guaranteed by the fast and diversified defrosting of the two evaporators (pg. 11).

The end of the defrost cycle is controlled by a special probe installed on the evaporator.

The single-phase version of the display case, in lengths 1625 mm (63.98”) and 2125 mm (83.66”), is equipped with two compressors to ensure the best thermodynamic performance. The L 1125 mm (44.29”) version has only one compressor with twin fan condenser, the second fan with a thermostat (pg. 11).  The gelato display case, in the single air flow configuration, is also available with dual temperature: possibility of adding a section with differentiated temperature for 3+3 pans and dedicated condenser unit. In the three-phase modules measuring L 1125 mm (44.29”)
and L 2125 mm (83.66”) the differentiated temperature is only possible in the display case with remote condensing unit.

In all the services, the lower supporting structure of Lumière is made of tubular steel epoxy powder-painted at 180° ensuring excellent resistance and long-term durability.

The tank and work surface in stainless steel are insulated against the formation of condensation to ensure a continuously dry surface and therefore maximum hygiene. The side is made of 25-mm-thick (0.98”) polyurethane. The condensing unit, when on-board, rests on a metal support base which slides on runners for easy extraction and cleaning. Condenser and internal filter protected by a stainless steel grille.

Gelato and Gelato/Pastry services.

The display surface is tilted 9° to allow perfect viewing of the gelato. The tank is equipped with 4 drainage holes (pg. 12). In the  Gelato/Pastry service the gelato pans can be replaced, on request, by a stainless steel cake tray. Gelato service with accessories Dry hot snack service Pastry service Gelato up to 8 cm (0.32”) from pan’s edge

Pastry service.

The display surface, 788 mm (31.02”) in depth, tilted at 5.5°, consists of a stainless steel tray with a glossy finish.  The trays can be removed to make the service and cleaning operations much easier.

Dry hot snack service.

The display surface, tilted 5.5°, is made of white tempered glass with heat-resistant screen printing.

The large front glass is curved, stratified and heated by tungsten wires that allow differentiated heating, which helps to save energy. With a handle integrated into the  upper profile, the front glass can be opened from top to bottom and the glass hinge is concealed for a more formal clean look.

The glass sides are double glazed, pyrolytic, heated and toughened, with a thickness of 24 mm (0.94”) to ensure perfect visibility at all times without condensation, while at the same
time keeping the cold air inside the display case.

The fixed upper shelf rests on the side uprights, is 194 mm (7.63”) deep and can be used as a handy serving top. The closure on the
operator side has an HCS high-performance rear closure system (pg. 11), available in the version with fibreglass closure panel or in the version with methacrylate sliding doors. The LED lighting is integrated into the overhead part.

On request, in the Pastry and Hot dry snack services it is possible to add a room temperature shelf.

Lumière can be customised with a sample finish or with the Ifi Collection Finishes. The plinth, in black coated sheet metal, can also be customised with a sample finish.

•  Lumière has adjustable feet. On request, it is possible to insert swivel wheels with a brake. The total height would increase 79 mm (3.11”).
•  The display case can be ducted in two ways:
  
  • with low glass partition in case of display case with same service;
  • with high glass partition in case of display case with different services.